18
Care & Cleaning
To Clean the Recessed and Contoured Areas of the Cooktop -
If a spill occurs
on or in the recessed or contoured areas, blot up spill with an absorbent cloth.
Rinse with a clean, damp cloth and wipe dry.
To Remove and Replace the Surface Burner Caps and Surface Burner
Heads -
Remove in the following order: (1st) surface burner grate, (2nd) surface
burner cap, (3rd) surface burner head and (4th) surface burner drip pan (if
equipped).
Reverse the procedure above to replace the surface burner cap, surface burner
head and surface burner drip pans (if equipped).
Do not remove any parts from
the cooktop until they have completely cooled and are safe to handle. Do
not operate the surface burners without the surface burner cap and surface
burner head properly in place.
To Clean the Surface Burner Cap, Surface Burner Head and Surface Burner
Drip Pan (if equipped) -
Use a soap-filled scouring pad or a mild abrasive
cleanser to clean the surface burner caps, surface burner heads and surface
burner drip pans (if equipped). The ports (or slots) around the burner head must
be routinely cleaned. If residue still remains in these ports, use a small-gauge wire
or needle to clean the slots or holes. For proper flow of gas and ignition of the
burner—
DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY
OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING.
ALWAYS
keep the surface burner cap and surface burner head in place whenever
a surface burner is in use.
Use caution when replacing the burner cap so the electrode is not damaged. This may cause a delayed ignition
or prevent the burner from igniting.
Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application
needs must be made by an authorized
Frigidaire
Distributor or Qualified Agency.
THE COOKTOP IS NOT REMOVABLE.
Do not attempt to remove or lift the cooktop.
T
o Remove and Replace Oven Door
To Remove Oven Door:
1.
Open the door.
2.
Remove screws located on the inside of the oven door near the hinges
A
(one on each
side.)
3.
Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up
and off the hinges.
4.
To clean oven door, follow the instructions provided in the cleaning table under
Care &
Cleaning.
To Replace Oven Door:
1.
Be sure the hinge arms are in the quarter-open position. Be careful if pulling the hinges
open by hand. The hinges may snap back against the oven frame and could pinch fingers.
2.
Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the
door.
3.
Hinge arms must go into the range slots evenly. The hinge arms should be inserted into
the bottom corners of the door as far as they can go.
4.
If the door is not in line with the oven frame, remove it and repeat the above steps.
The door is heavy. For safe, temporary storage, lay the door flat with the inside
of the door facing down.
Summary of Contents for ES200/300
Page 1: ......
Page 6: ...6 Features will vary according to model Features At A Glance ...
Page 22: ...Notes Page ...
Page 23: ...Notes Page ...
