FRIEDLAND Spectra Plus L420N BLK, Instruction Manual, Page: 10 / 104

Testing:
The system may be tested by placing the PIR
into Walk Test, (see “PIR Walk Test”).
The Receiver may also be tested on its own
by briefly operating the learn button
(see “Testing the Receiver”).
Expanding or Resetting Your System
Your system can be expanded by adding
additional PIR detectors and also by linking in
Libra Plus door chime pushes. Up to a
maximum of 10 PIRs or Chime Pushes may
be linked to the receiver. Remember that if
you have more than one PIR Detector in the
same system the light or lights will stay on
until the last detector no longer detects any
movement, and then continue to be illuminated
for the duration of the ‘light on’ timing you
have chosen.
Important: Do not attempt to reset your
Receiver or learn the codes of additional
devices to expand your system if it is set or
raining and always follow manufacturers
guidelines when using ladders.
Notes: Signals from existing linked devices
will not activate the lights while the receiver is
in program mode. If no signal is received
within 3 minutes the receiver will automatically
exit program mode.
Adding a Spectra Plus Wirefree PIR Detector:
To program an additional PIR into the receiver
first activate the PIR and configure it for “Walk
Testing”. Undo the four cover screws and
remove the cover from the Receiver. Press
and hold the program button down for
approximately 3 seconds until the LED starts
flashing slowly and program mode is activated.
The LED will continue to flash slowly waiting
for a signal from a device. Trigger the PIR
detector by moving around in front of it, the
receiver will record the ID code of the door
push into memory and automatically exit
program mode.
Adding a Libra Plus Chime Push Switch:
The receiver can be linked to a Friedland
Libra Plus Door Push which will activate the
lighting for a fixed time period of 3 minutes.
To program a Libra Plus Door Push into the
receiver first undo the four cover screws and
remove the cover. Press and hold the pro-
gram button down for approximately 3
seconds until the LED starts flashing slowly
and program mode is activated. The LED will
continue to flash slowly waiting for a signal
from a device. Press the button on the Libra
Plus Door Push, the receiver will record the
ID code of the door push into memory and
automatically exit program mode.
Resetting the Receiver:
If for any reason you need to completely reset
the receiver and erase all linked devices:
First undo the four cover screws and remove
the cover. Press and hold the program button
down for 10 seconds until the LED starts
flashing quickly. The LED will continue to
flash for 5s while any linked devices are
being erased. The LED will then flash slowly
waiting for a signal from a device to be linked.
The Receiver will now have to relearn the
identification codes of any devices in your
system
9