3)
Do not position the unit where it is exposed
to draughts.
4)
Do not position the unit directly above a
strong heat source.
5)
Do not position the unit where it is subject
to excessive vibration.
6)
The PIR Alarm Unit should be positioned
within a 1.9m cable run from the Magnetic
Contact position. Ensure there is sufficient
cable left to connect to the PIR Alarm Unit.
The Magnetic Contact is fitted with fixed
connection cables that cannot be extended.
INSTALLATION
Configuring the Remote Control:
1)
Slide off the battery cover.
2)
Select a random ON/OFF combination for
the 4 DIP switches located in the battery
compartment. This is the House Code that
enables the Remote Control and PIR Alarm
Unit to communicate.
3)
Set operating mode switch to ALARM or
CHIME according to the required operating
mode.
4)
If fitted, carefully remove the battery
isolation tab from between the batteries. If
the batteries are dislodged replace them
noting the correct polarity shown inside the
battery compartment.
5)
Replace the battery compartment cover.
Magnetic Contact Detector:
6)
Fix magnet to opening part of door/window
along the opening edge opposite the
hinges using the adhesive pad supplied.
7)
Fix Magnetic Contact Switch to fixed part of
door/window frame beside the Magnet
using the adhesive pad supplied. Ensure
that the gap between the Magnet and
Contact Switch is less than 12mm when the
door/window is closed and the arrows align.
8)
Run the cable back to the PIR Alarm Unit,
(the cable cannot be extended).
PIR Alarm Unit:
9)
Hold the mounting bracket in position on
the wall and mark the position of the two
fixing holes.
10) Fix the mounting bracket to the wall using the
fixing screws and wall plugs supplied, (a
6.5mm hole will be required for the wall plugs).
Note: The wall plugs supplied are not
suitable for use in plasterboard walls.
11) Undo the battery cover fixing screw and
remove the cover.
12) Insert 3 x AA (LR6) Alkaline batteries noting
the correct polarity shown inside the
battery compartment.
13) To program the house code on the PIR
Alarm Unit press the LEARN button located
in the battery compartment. The LED
indicator on the front will start flashing.
14) Point the Remote Control at the PIR Alarm
Unit and press the ARM button for 1s. The
Unit will beep and the LED will stop
flashing when the signal is received.
House Code
Switches
Mode Selector
Switch
Batteries
Fixing
Screw
PIR Movement
Sensor
Wall Mounting
Bracket
Siren
LED
Indicator
Infra-Red
Receiver
LEARN
EXT
TRIGGER
SENSOR
EXT
SIREN
Magnetic
Contact
connection
Learn Button
Battery
Compartment
