SUN30
8
EN
Troubleshooting
Action
Cause
Symptom
Contact Frico Technical Support.
The unit's sound level
has increased.
The filter is clogged or the unit is placed
on an uneven surface.
Clean the filter or put the unit on
a flat surface.
The unit does not
work.
The power is not connected.
Insert the plug into the wall
outlet and push the ON button.
The room is too big.
Use several units or a
dehumidifier with a greater
capacity.
The water tank is full.
Empty the tank.
There is too much ventilation.
Reduce ventilation, close doors
and windows.
The filter is clogged.
Clean the filter.
The tank is not correctly inserted.
Position the tank correctly.
Ambient temperature or humidity is
not within the recommended operating
ranges.
The air does not pass freely through the
unit.
Make sure the air inlet and outlet
are not obstructed.
The drain hole under the evaporator is
clogged.
Clean the drain hole.
The continuous drainage is not working
correctly.
Check that the hose is installed
correctly and that the water
drains away freely.
The display does not
show the set humidity.
This is normal. The display shows the
current humidity, not the set point.
The set humidity is shown by
LEDs on the control panel.
There is water on the
floor.
The dehumidifier has been moved with
its water tank filled or the water tank has
been removed carelessly.
Empty the water tank before
moving the dehumidifier. Be
careful when removing the water
tank.
Recommended operating ranges
for SUN30 are 8-32°C, 30-100%
RH.
The dehumidification
capacity is too low.
The set humidity is higher than the
current humidity.
Set the humidity lower than
current humidity.
The water tank is broken.
If the fault cannot be rectified, please contact a qualified service technician.
