E1
E2
E3
E4
E5
E6
E7
E8
CP
OF
Soloclim
18
EN
Cause
Error code
Contact lost with control panel
Outdoor temperature sensor fault
Operating modes
Maximum float level reached.
Should any anomaly occur in the condensation water
system, the level float will stop the unit and the error code
"OF" appears on the display.
During cooling and dehumidification, electronics keeps
the water distribution system active in the coil - together
with the fan - to disperse excess water in the drip tray. If
the problem persists, please contact the Frico technical
support.
When in operation, condensation should drain freely
through the designated tube. In the event of an alarm,
check that the tube is not bent or obstructed, thus
preventing the water from flowing out.
Cooling, Dehumidification and Heating modes can still be
activated. It only monitors the antifreeze function of the
internal coil.
Cooling, Dehumidification and Heating modes can still be
activated.
Cooling, Dehumidification and Heating modes can still be
activated. Defrosting is performed at fixed times.
None of the modes can be activated.
The unit only works if the contact is closed. Check the
connections. See ”CP presence contact”.
Open CP presence contact.
External coil sensor fault
Internal coil sensor fault
Room temperature sensor fault
Internal fan motor fault
External fan motor fault
If the fault cannot be rectified, please contact Frico Technical support specifying the error code to simplify intervention.
Compressor discharge fault
