Soloclim vertical
12
EN
Control panel
Remote control
On / off
Fan mode
Timer
Hotel function
Decrease / down
Increase / up
Setpoint
Air deflector
Automatic comfort mode
Digital thermometer:
Red bars - heating mode, blue bars - cooling
mode
Cooling mode
Dehumidification mode
Heating mode
Comfort mode Night
Setpoint
When the unit is on, the set value is shown on
the display with three digits. The setpoint value
can be set between 16 and 31°C. The setpoint
must not be set too high or low, as this means
unnecessary energy consumption and reduced
comfort.
On / off
The unit can be switched off (standby) or on
with this button. The system is equipped with a
memory, which means that the settings will not
be lost when the unit is turned off or the power
is switched off. The button is used to switch on or
off, for short periods.
If the unit is to be switched off for a long time,
the main switch must be switched off and the
power cord pulled from the socket.
Automatic comfort mode
The unit selects cooling or heating mode
automatically depending on the set temperature
and its fan speed according to the room
temperature.
Setting cooling or heating mode
To deactivate the heating or the cooling mode do
as follows:
• Keep the A key on the touch-screen display
pressed for 10 seconds until HC (heating and
cooling) appears on the display.
• Press the A key for 1 second to switch to
cooling mode (CO).
• Press the A key again to switch back to heating
mode (HO).
• Wait for 3 seconds without touching anything
to memorise the setting.
Cooling mode
In this mode, the unit dehumidifies and cools
the room. Use the up/down buttons to set the
temperature.
The desired temperature can be set between 16
and 31°C and, if this temperature is lower than
the room temperature, the compressor starts
after three minutes (maximum) and the unit
starts producing cool air, maintaining fan speed
even if the setpoint has been reached.
Control
Soloclim is controlled by the touch-screen control panel on the front of the unit or
by the supplied remote control.
Setting power
