Fri-Jado STG5, Manual, Page: 7 / 24

en / 2-3
INTRODUCTION, INSTALLATION AND INITIAL USE
Press one of the sides at a spot about halfway
down from the top.
Keep the necessary care in mind when moving
the equipment over obstacles or steps.
Your STG is not suitable to be used in a rainy
or very humid environment, because of the
danger of short circuiting.
Your STG must not be cleaned with a water-
spout,becauseofthedangerofshortcircuiting.
For cleaning instructions see chapter 4.
When fitting or changing the spits or other
accessories, first stop the grill rotor.
During the grilling process the equipment can
become very hot; in particular, the window
and the top.
Clean the grill regularly to ensure correct
operation and avoid possible fire risks
(through overheating). The fan cover and the
fan blades should be cleaned regularly.
Empty the fat tray promptly to avoid over-
flowing.
Push the fat tray completely into the grill
after placing it back to prevent damage
to the window.
With an eye to hygiene, warmth isolation and
a perfect grip oven gloves should preferably
be dry and fat-free during use.
1.4.2 Hygiene
The quality of a fresh product is always partially
dependent on hygienic conditions. This is espe-
cially true for grill products. Due to the possibility
of transferring salmonella bacteria, you should
ensure that already grilled product, especially
chicken and turkey products, do not come into
contact with raw products. Contact between
grilled products and hands or tools that have
come into contact with raw chicken or turkey
meat should also be avoided at all times.
If hands and/or tools have come into contact with
raw chicken or turkey meat, the hands and tools
should be cleaned thoroughly.
1.4.3 General conditions and guarantee
Fri-Jado has paid a gr eat deal of attention to
quality and guarantees the suitability and good
working order of your equipment.
For complaints, requests, reporting shortages and
for ordering accessories, you can contact your
supplier.
2 INSTALLATION AND INITIAL USE
2.1 Packaging and transportation
requirement
The STG is packed in a plastic cover, protective
corner pieces and protection for the glass at the
front and rear side, all enclosed in a cardboard
box. The equipment is mounted on a wooden
pallet. Two securing straps are fastened around
the box and pallet.
During transportation the transportation requi-
rements should be observed. For this purpose
the following symbols are marked on the card-
board box:
The top indicated by the arrows
uppermost.
Keep the packaging dry.
Do not use hooks for lifting and tipping.
Fragile contents, handle with care.
In its packaging, the STG can be transported with
a forklift truck or hand lift trolley.