Fri-Jado STG5, Manual, Page: 6 / 24

en / 2-2
1.4 Safety, hygiene and guarantee
1.4.1 Safety
In this manual the following warning symbols are
used:
Denotes risk or personal injury, loss of
life or damage to the equipment in case
of non-observance of the instructions in
this manual.
Electrical power.
Burning hazard.
Stickers are applied to the equipment (see figure
1.1): they warn you about surfaces with a high
temperature. The windows and the top side of
the equipment can reach high temperatures.
Figure 1.1
During use of your STG, the following safety
precautions should be observed:
When moving your STG, first switch off the
power by taking the plug out of the socket
and let the equipment cool down for at least
10 minutes.
Empty out the fat tray before moving the
equipment.
Push the fat tray completely into the STG
after placing it back and close the drain
to prevent damage to the window.
INTRODUCTION
1.3.2 Technical description
A combination of direct infrared radiation and
convection heat is used in the STG. The radiation
heat seals the meat and creates a crispy brown
layer; the convection heat cooks the meat proper-
ly. An ingenious, patented ventilation system
completes the package. That way the STG gives
a perfect result every time.
The grilling process is controlled through
preprogramming. The settings can be changed
during the entire process.
During the grilling process, the heating elements
and the quartz light on the serving side are
constantly switched on and off. The quartz light
on the customer side stays lit during the entire
process. A maintenance-free engine with a re-
duction gear drives the grill.
The fans provide an even heat distribution and at
the same time they cool the exterior walls of the
grill. Since the heat sources are located in the top
of the grill, the amount of pollution, and thus also
the amount of smoke production, is minimised.
A heat reflecting coating has been applied to the
inside surfaces of the windows to keep the heat
inside the STG.
It is possible that your STG is combined with an
STG of the same size, or with a heated cabinet
from the STG series, on top of each other and
equipped with wheels.
In that case each of them must be operated
individually.
The metalwork is made of stainless steel (stainless
steel 304 and stainless steel 430). The electrical
cable is fitted with a CEE model plug.
The type plate with the data that is appropriate
for your grill is affixed on the side panel next to
the operating panel.