Installation Manual Multi Deck 60/100/120 / Classic Deck form 9123789 rev. 06/2009
Page 16
INSTALLATION OF THE MULTI DECK 60/100/120 & CLASSIC DECK HOT
INSTALLATION
LOCATION
Immediately after unpacking the merchandiser, check for possible shipping damage. If the
merchandiser is found to be damaged, save the packaging material and contact the carrier
within 15 days of delivery. Prior to installation, test the electrical service to assure that it
agrees with the specifications on the machine data plate located on the right side panel near
the controls.
The merchandiser must be installed on a level surface. The installation location must allow
adequate clearances for servicing and proper operation.
AIR GRID
Take care that a free airflow around the on
the top is secured. This is to prevent the elec-
tronic ballast for overheating.
The connecting cable for the unit must be equipped with an approved plug connection. If
use is to be made of a permanent connection, the connecting cable must be connected to a
manual on/off switch that is installed near the unit in a clear visible manner.
INSTALLATION
Install bottom panels
1. Put the brake on the castors.
2. Hang the side panels over the suspension points and slide them forward.
3. Position the front panel on the screws on the front side of the side panels.
4. Fold the front panel forward and hook the top side around the edge of the plate above
it.
Note:
After unpacking of the ma-
chine you can find the packed
panels on top of the unit.
