
Flughandbuch XCitor
- 11 -
This table describes the functions of these elements:
On the panel: (Equipment my vary depending on the version)
Name
Number
Positions
Purpose
Main Switch
1
ON OFF
Main switch for the
electrical system
including ignition
Interkom
2
Refer to its separate
manual
For communication and
radio
Water temperature
4
Between 80 and
105°C
Water temperature
monitoring
RPM
5
In cruise between
4200 and 5000 rpm
Display of motor rpm
Start switch
6
Un- /pressed
Press to start engine
Charging check light
7
Red light
When electrical system
on and red light off then
battery will be charged
correctly
Beside the panel:
Name
Positions
Purpose
Gas pedal
Up / down
Giving gas with the right foot
Brake pedal
Up / down
Braking of the front wheel with
the left foot
Trim lever
Fore / aft
Works like the brake line: In
order to fly faster pull both levers
aft, for curve flying push inner
lever fore
Cruise gas lever
Fore / aft
Used for gas setting during
cruise. With the gas pedal only
more gas than set with the cruise
gas can be applied, never less!
Control (brake) lines
(not) pulled down
Used to steer the canopy
especially during take off, landing
and under turbulent conditions
The amount of remaining fuel can be easily judged in flight due to the transparent
fuel tank wall .
ENGINE START PROCEDURE
Main Switch
ON. Charge light on
Gas pedal
Cold engine: kick pedal 50&down until
fuel is injected for ca. ½ sec. Can be
heard. Then don’t give any gas at all.
Warm engine: Kick pedal slightly down,
ca. 10%.