Installation
Dimensions
6.4″
3.7″
2.4″
4.6″
5.7″
2.0″
2.0″
1.1″
1.1″
1.8″
HANDLE CONNECTOR
THREE -WAY CONNECTOR
HANDLE
VALVE COVER
O-RING
O-RING
BASE WASHER
BASE
WASHER
RING
BRASS WASHER
BRASS
WASHER
FEMALE SCREW
FEMALE
SCREW
HEAD-SCREW
HEAD
SCREW
SUPPLY LINES
SUPPLY
LINES
FAUCET
CAP
GRUB SCREW
VALVE
2
Unit:inches
This faucet meets or exceeds the following standards:
ASME A112.18.1/CSA B125.1/NSF61-9
This product has been tested and certified by IAPMO.
IAPMO LISTED
Fit O-ring into the groove in the underside of faucet.
Place the faucet in the position on the basin. Tighten the base washer, the brass washer with the female screw
from the under-side of the counter. Check that the faucet is correctly positioned, and install the three way
connector by screwing onto the threaded tail pipe of the faucet.
Install valve into specified drill hole under-side the counter. Place o-ring into under the valve cover. Screw valve
cover
into valve. Adjust the height and position of valve, then screw female screw to tighten valve from the under-side
of counter securely.
Install handle to handle connector of valve. Tighten grub screw with Allen key and then place cap on handle.
Screw supply lines into three way connector and valve. Connect the water supply pipes to the tail of supply lines
with the hot water and cold water.
1:
2:
3:
4:
5:
