Installation
Dimensions
SUPPLY LINES
RUBBER WASHER
PLASTIC WASHER
FEMALE SCREW
HEAD SCREW
10 1/8″
13 1/4″
6 1/8″
4 3/4″
4 7/8″
Unit:inches
2
This faucet meets or exceeds the following standards:
ASME A112.18.1/CSA B125.1/NSF61-9
This product has been tested and certified by IAPMO.
IAPMO LISTED
To remove the cartridge.
First shut off the water supply to the tap.
1: Unscrew the handle from the cap.
2: Loosen the grub screw in cap.
3: Take off the cap, unscrew the cartridge cover.
4: Unscrew the retaining nut.
5: Pull the cartridge and wash it with clean running water.
6: Dry and lightly grease the seals (only use silicone grease)
FAUCET
Max 1.1″
HANDLE
CARTRIDGE
COVER
GRUB
SCREW
RETAINING
NUT
CAP
CARTRIDGE
FAUCET
WASHER
PEDESTAL
1: Fit the washer into the underside of the faucet.
2: Screw the supply lines into the faucet and fully hand tighten.
3: Pass the tail of supply lines through the hole on the basin from above, and place the faucet in position on the basin, to see if any
alteration to the existing supply pipe work is necessary, make any necessary alterations to the pipe work.
4: Tighten the rubber washer, the plastic washer with the female screw from the underside of the counter.
5: Check that the faucet is correctly positioned, fully tighten the female screw.
6:
Connect the water supply pipes to the tail of supply lines with the hot water and cold water.
