User’s manual - Mik
V1.1
03/2020
5/8
4. Routing with the Dante™ Controller
In order to configure the audio streams you need to:
1) In the main window, in the «Routing» tab, open the channels of the transmitting device
on the right «Dante™ Transmitters» and the channels of the receiving device under
«Dante™ Receivers» by clicking on the + buttons.
2) Click on the intersection point between the transmitter channel and the receiver
channel.
3) Wait until the field displays a green circle with a white check mark. For other
connections, repeat these three steps. You can download a User Guide for the Dante
Controller on the Audinate website:
https://www.audinate.com/resources/technical-documentation
5. Modes of operation
1) Selecting the Speech mode: With the speech mode selection switch on the underside
of the base plate, you can choose from 4 different speaking modes :
- PTM (Push To Mute): The microphone is in continuous operation. To temporarily mute the
microphone, press and hold the button.
PTT (Push To Talk): The microphone is switched off continuously. To activate it temporarily,
press and hold the button.
- ON /OFF: Once the base is switched on, the microphone is in operation. Each time the
button is pressed, the microphone status is switched between on and off.
- OFF/ON: The microphone is switched off when the base plate is switched on. Each time
the button is pressed, the microphone switches between on and off.
Operating Instructions - MikV1.109/20186/82) Audio settings
With the attenuation selector switch on the underside of the base, you can optimize the
gain in relation to the connected microphone :
0 dB = no signal attenuation (+ 50 dB gain)
10 dB: 10 dB signal attenuation (+ 40dB gain)
20 dB: 20 dB signal attenuation (+ 30dB gain)
30 dB: 30 dB signal attenuation (+20dB gain)
With the high-pass filter activation switch (80 Hz, 18 dB/octave), you can eliminate
disturbing noise at low frequencies.
