14
INSTALLATION INSTRUCTIONS
•
Ensure that there is a distance of 50 mm between the hob and the wall or sides.
•
The hobs are classifi ed as “Y” class for heat protection. Ideally the hob should be installed with plenty of
space on either side. There may be a wall at the rear and tall units or a wall at one side.
On the other side,
however, no unit or divider must stand higher than the hob.
•
The piece of furniture or the support in which the hob is to be fi tted, as well as the edges of furniture, the
laminate coatings and the glue used to fi x them, must be able to resist temperatures of up to 100 °C.
•
The mural rods of edge must be heat-resisting.
•
Not to install the hob to the top of a not ventilated oven or a dishwasher.
•
To
guarantee
under the bottom of the hob casing a space of 20 mm
to ensure a good air circulation of
the electronic device.
•
If a drawer is placed under the work, avoid to put into this drawer fl ammable objects (for example: sprays)
or not heat-resistant objects.
•
Materials which are often used to make worktops expand on contact with water. To protect the cut out
edge, apply a coat of varnish or special sealant. Particular care must be given to applying the adhesive
joint supplied with the hob to prevent any leakage into the supporting furniture. This gasket guaranties a
correct seal when used in conjunction with smooth work top surfaces.
•
The safety gap between the hob and the cooker hood placed above must respect the indications of the
hood manufacturer. In case of absence of instructions respect a distance minimum of 760 mm.
•
The connection cord should be subjected, after building, with no mechanical constraint, such for example
of the fact of the drawer.
WARNING: Use only hob guards designed by the manufacturer of the cooking appliance or indicated by
the manufacturer of the appliance in the instructions for use as suitable or hob guards incorporated in
the appliance. The use of inappropriate guards can cause accidents.
ELECTRICAL CONNECTION
The installation of this appliance and the connection to the electrical network should be entrusted
only to an electrician perfectly to the fact of the normative regulations and which respects them
scrupulously.
•
Protection against the parts under tension must be ensured after the building-in.
•
The data of connection necessary are on the stickers place on the hob casing near the connection box.
INSTALLATION INSTRUCTIONS
