According to our testing experience, use the following parameters to set aileron/elevator
rate, it will be useful for flight. In low rate, it will operate more stable. In high rate, it will operate more
sensitive. We advise to use high rate in your first flight, then according to your habit to choose
low/high rate.
Low Rate
High Rate
Aileron
H1/H2 30mm/30mm
D/R Rate: 70%
H1/H2 40mm/40mm
D/R Rate: 100%
H1/H2 30mm/30mm
D/R Rate: 85%
H1/H2 34mm/34mm
D/R Rate: 100%
H1/H2 20mm/20mm
D/R Rate: 85%
H1/H2 26mm/26mm
D/R Rate: 100%
H1 32mm
H1 50mm
H1
H2
H1
H1
H2
H1
H2
PNP lnstall instructions
Aileron
Flaps
Elevator
Rudder
Elevator
Rudder
Flaps
Dual rates
Flight Attention:
1.Correct elevator center position
After install, we need to adjust the elevator, correct
elevator center position, please refer to the right photo.
After adjust, elevator looks a little up, it has a little up
elevator.
2.Flap-elevator mix parameter
When open the flap, the jet will change the flight
direction, it will fly up the sky. In order to operate better,
we advise you set the “Flap-elevator mix” in radio. In
this case, when you open the flap, the jet don’t change
its flight.
Setting range is as following:
Open flap 50mm, pre-set 3mm elevator down
Open flap 32mm, pre-set 2mm elevator down
At last, according to your operating, you can increase or reduce its rate.
10
A-10 Thunderbolt II
Item No.:FJ311
