2201 Cantu Court Suite 215 Sarasota, FL 34232 Page 15 of 23
(941) 378-4242 (800-237-3928 Fax (941) 378-2765
Stewartsigns.com
Figure #20 Transceiver inside the Sign.
Connect the RS232 Cable to “COM 1”
2.
On ID cabinet ID#1, open the Lid on the LED portion of the sign by removing the
Phillips screws on the bezel surrounding the Lexan Lens.
3.
Unscrew the Wing Nuts at the bottom of the LED panel and remove the bolts. Raise
the LED panel. Use the aluminum post located inside the sign to prop the LED
paned up. This will expose the electronics mounted to the inside rear of the LED
cabinet.
4.
Attach the Antenna Cable to the Antenna Port on the Transceiver. Figure #20
5.
Attach the Plastic Mounting Shoe. To the inside of the sign just below the electronic
circuit boards using sheet metal screws. Snap the transceiver into the Mounting
Shoe.
CAUTION: Do not place any electrical devices on the inside bottom of the LED
cabinet. Water can collect in this location before draining out of the
weep holes.
6.
Connect the AC adapter provided to the AC receptacle inside the sign. It is highly
recommended to secure the AC adapter to the receptacle with a nylon zip tie.
Connect the other end to the power Receptacle on the Transceiver.
