Freescale Semiconductor MPC5565, Reference Manual

Page: 842 / 1153

Deserial Serial Peripheral Interface (DSPI)
MPC5565 Microcontroller Reference Manual, Rev. 1.0
Freescale Semiconductor 19-19
19.3.2.4 DSPI Status Register (DSPI x _SR)
The DSPI x _SR contains status and flag bits. The bits are set by the hardware and reflect the status of the
DSPI and indicate the occurrence of events that can generate interrupt or DMA requests. Software can
clear flag bits in the DSPI
x _SR by writing a 1 to clear it (w1c). Writing a 0 to a flag bit has no effect.
28–31
BR[0:3]
Baud rate scaler. Selects the scaler value for the baud rate. Use in master mode only. The pre-scaled system clock
is divided by the baud rate scaler to generate the frequency of the SCK. The following table lists the baud rate scaler
values.
The baud rate is computed using the following equation:
Note: Refer to Section 19.4.6.1, “Baud Rate Generator ,” for more details.
Address: Base + 0x002C Access: R/W
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
R TCF TXRXS 0 EOQF TFUF 0 TFFF 0 0 0 0 0 RFOF 0 RFDF 0
W w1c w1c w1c w1c w1c w1c
Reset 0 0 0 0 0 0 1 0 0 0 0 0 0 0 0 0
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
R TXCTR TXNXTPTR RXCTR POPNXTPTR
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Figure 19-6. DSPI Status Register (DSPI x _SR)
Table 19-5. DSPI x _CTAR n Field Description (continued)
Field Description
BR
Baud Rate Scaler
Value
BR
Baud Rate Scaler
Value
0000 2 1000 256
0001 4 1001 512
0010 6 1010 1024
0011 8 1011 2048
0100 16 1100 4096
0101 32 1101 8192
0110 64 1110 16384
0111 128 1111 32768
SCK baud rate
f
SYS
PBRPrescalerValue
----------------------------------------------------------
1 DBR +
BRScalerValue
--------------------------------------------
×
=