FRDMKL02ZUM
FRDM-KL02Z User Manual
Page 10 of 12
6.
FRDM-KL02Z OpenSDA Overview
By default the FRDM-KL02Z board comes pre-programmed with the OpenSDA Bootloader.
Using the OpenSDA Bootloader
1.
Press and hold the Reset/Bootloader pushbutton while you plug in a USB cable (A to mini-B) to
the OpenSDA USB connector (J2). Release the pushbutton.
2.
The FRDM-KL02Z should enumerate as a mass-storage device with a volume label of
"BOOTLOADER".
3.
You may now drag/drop or copy/paste OpenSDA applications (e.g. Debug App, MSD
Programming App, CMSIS-DAP) to your OpenSDA drive. Applications can be found in the
"applications" folder of the OpenSDA package.
4.
Unplug the USB cable and plug it in again
(Note: this is a step that will not be required on future versions of the OpenSDA bootloader)
5.
You should now be running the programmed OpenSDA application.
6.
To boot back into the Bootloader, start over at step #1.
Reading the installed OpenSDA hardware information
1.
Boot into the OpenSDA bootloader mode by following the steps in "Using the OpenSDA
Bootloader" section.
2.
Open "BOOTLOADER" mass-storage device drive.
3.
Open SDA_INFO.HTM file with any web browser. An HTML page will open with your Freedom
OpenSDA hardware information; including bootloader and application installation details.
4.
This HTML page will also include links to download the latest OpenSDA Firmware (MSD &
Debug applications) as well as USB Drivers for OpenSDA CDC device.
Installing the OpenSDA CDC Drivers
The Debug and MSD applications both include a CDC device for USB serial port. The following
instructions are specific to Windows 7.
(Note: Driver installation for other operating systems may be slightly different)
Recommended Driver Installation Process
1.
Download the latest “Windows USB Drivers” from the OpenSDA Support page accessed by
selecting the “SDA_INFO.HTM” link located on mass-storage device enumerated from the
connected FRDM-KL02Z
2.
Disconnect the FRDM-KL02Z from the host PC and install the downloaded Windows USB Driver
installation executable.
3.
Once the installation is complete, plug in your board that has be programmed with either the
MSD or Debug application.
4.
Windows should automatically enumerate as an OpenSDA – CDC Serial Port.
If the driver enumeration fails, the driver can be ma
Manual Driver Installation Process using the include INF file
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
