FREERIDER FR-S13 Series, User Instruction Manual

Page: 16 / 29

VI. BASIC TROUBLESHOOTING
Recommended fuse rating:
Charger 10A.
Lights circuit 10A.
16
1.
2.
Warning!
Please confirm to the recommended fuse rating, or may cause permanent
failure to the wiring and wiring connectors or personal injuries.
For access to a fuse, removing the rear cover, lift cover locate and lift the
fuse block, lift up the fuse lid. Replace the blown fuse and close fuse lid
and replace fuse block.
Working Fuse Blown Fuse
When the scooter fails, most of the time the reason is due to the loss of
electromechanical functions. Usually, the scooter can operate normally through
some simple recovery or through the fault indicator. The fault indicator please refer
to "Status Fault Codes". If there are any problems or problems that cannot be
suspected, please contact your authorised dealer.
If your scooter will not start:
Check the power key switch is turned "on". If it is, the battery condition indicator
meter will be operating. If the status light on your console is flashing, please refer to
"Status Fault Codes".
If the battery condition meter and the status light fail to operate when
the key switch is in the "on" position, check the following:
Make sure the battery charger is not plugged into the tiller charge socket, this will
prevent drive.
Check both battery connectors. Check battery terminal condition.
Check the "circuit breaker" or fuse.
If your scooter stops for no apparent reason, it is probably due to the circuit
breaker disconnecting from the speed control electronic box.
A.
B.
C.
D.
One fuse protects your scooter charging circuit from receiving an overload of
electrical current. The fuse used in the scooter is the same type which is found on
automobiles. In the unlikely event that a fuse should 'blow' and needs replacing.
Please use fuse with the recommended fuse rating. Please note that this size of fuse
has been selected to give your scooter the best protection without premature fusing.