8
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance on
the exterior of the treadmill. This is normal. If there
is an oily substance on the treadmill, wipe it off
with a soft cloth and a mild, non-abrasive cleaner.
• To identify small parts, see page 7.
• Assembly requires the following tools:
the included hex key
one Phillips screwdriver
one adjustable wrench
To avoid damaging parts, do not use power tools.
ASSEMBLY
1.
Make sure that
the Power Cord
is unplugged. Be
careful not to pinch
the Power Cord.
Slide the Upright Cover (not shown) off the
Upright (81).
Orient the Upright (81) and the plastic ties as
shown. Set the Upright on the tabs on the Frame
(53). Attach the Upright with four 3/8" x 3 1/4"
Screws (1), two 3/8" Star Washers (2), and two
3/8" Flat Washers (43). Start all four Screws,
and then tighten them. Be careful not to
pinch any wires.
81
53
1
1 2
Plastic Ties
1
1
!
!
43
43
