12
MAINTENANCE AND TROUBLESHOOTING
Inspect all parts of the vibration platform regularly. Some replacement parts are available; for information about
ordering replacement parts, see the back cover of this manual.
Clean the outer surfaces of the vibration platform, if necessary, with a damp cloth and mild, non-abrasive deter-
gent;
do not use solvents to clean the vibration platform.
Most vibration platform problems can be solved by following the simple steps below. Find the symptom
that applies, and follow the steps listed. If further assistance is needed, please see the back cover of
this manual.
PROBLEM: The power does not turn on
SOLUTION:
a. Make sure that the power cord is fully plugged into the receptacle on the base of the vibration
platform. Next, make sure that the power cord is plugged into an appropriate outlet (see page
9).
IMPORTANT: The vibration platform is not compatible with GFCI-equipped outlets.
b. Check the on/off switch located on the vibration plat-
form base near the power cord. Make sure that the
on/off switch is in the on position.
c. If the power cord is plugged in and the on/off switch is in the on position, the fuse may need to
be replaced.
To replace the fuse, first switch the on/off switch to the off position and unplug the power cord.
Remove the power cord from the jack on the side of the vibra-
tion platform. Then, using a flat-head screwdriver, remove the
fuse holder located above the plug jack. Remove the fuse
from the fuse holder.
Check to see if the wire inside the fuse is intact. If the wire is
broken or faulty, discard the fuse and insert a new fuse into
the fuse holder. Note: The correct type of fuse to use is listed
on the fuse holder. There may be an extra fuse included in
the fuse holder.
Then, replace the fuse holder and plug the power cord into the jack.
Plug in the power cord, switch the on/off switch to the on position, and run the vibration platform
to check for correct operation.
d. If the vibration platform still will not run, please see the back cover of this manual.
Off
On
b
Fuse Holder
Plug Jack