10
ADDITIONAL ADJUSTMENT
Top Weight Adjustment—
Tools required: Hammer, 1/8" punch, 3/16" roll pin
1. Lift the coupler cover from the top weight coupler.
2. Remove the roll pin from the top weight coupler
with an 1/8" punch and a hammer.
3. Align the hole in the cable coupler with the
appropriate adjustment hole in the top weight
coupler:
• If more slack is needed in the cable, align the
cable coupler with a higher hole.
• If less slack is needed in the cable, align the
cable coupler with a lower hole.
4. With the cable coupler aligned with the new hole,
drive a new roll pin into the top weight coupler
and cable coupler.
5. Lower the coupler cover over the top weight
coupler.
CABLE ADJUSTMENTS
CAUTION:
After making any cable adjustment, pull
the leg lever using a light load and have someone
make sure that the cable is not derailed from a pul-
ley or rubbing on a guard (see CABLE GUARDS on
page 9).
INITIAL ADJUSTMENT
Tower Pulley Adjustment–
Tools required: 5/16" hex key, 9/16" open end
wrench
1. Lift the top weight off the
weight stack and insert
the weight pin into the
third weight and the sixth
hole from the top of the
weight rod.
2. Loosen the locknut
attaching the pulley to the
bracket in the top of the
tower.
3. Move the pulley to the appropriate location in the
bracket:
• If more slack is needed in the cable, move the
pulley downward.
• If less slack is needed in the cable, move the
pulley upward.
4. Make sure that the pulley guard is properly ori-
ented (see CABLE GUARDS on page 9) and
retighten the locknut attaching the pulley to the
bracket.
5. Lift the top weight and remove the weight pin.
Lower the top weight onto the third weight.
6. Readjust as necessary.
Locknut
Set Screws
Cable
Top Weight
Coupler
Coupler Cover
