Revised 4/3/17
CONTROL BOX
AND BRACKET
CONNECT TOP
AND BOTTOM
TABS TO THE
HOSE CLAMPS
HOSE
CLAMP (2)
STEP 1
Assembly Instructions
TOOLS REQUIRED:
9/16” WRENCH
3/4” WRENCH
1/8” HEX KEY
FLATHEAD SCREWDRIVER
The Power EZ Pool Lift arrives with the boom arm attached
to the mast. To complete the assembly, layout all parts on a
large, clean area.
STEP 1.
Attach the control box to the lifts mast using the
STEP 2.
Connect the lower end of the electric actuator to
the mast (vertical post) with one (1) 3/8” x 1 3/4” hex bolt,
STEP 3.
Connect the upper end of the actuator to the
washers and one (1) 3/8” nylock nut.
STEP 4.
Slide the lift into the previously installed anchor
socket. Make sure that the mast is seated at the bottom of
the anchor. Check to ensure easy rotation of the lift inside
the nylon-lined anchor sleeve.
NOTE: Three (3) zip ties shipped with the Power EZ Lift.
These are meant to secure excess actuator cable. Failure to
complete this may cause a tripping hazard. See the pictures
below on how to attach the cable to the lift.
MAST
3/8" X 1 3/4"
HEX BOLT
3/8" FLAT
WASHER (2)
3/8"
NYLOCK
NUT
STEP 2
ACTUATOR
3/8"
NYLOCK
NUT
3/8" X 1 3/4"
HEX BOLT
3/8" FLAT
WASHER (2)
BOOM
ARM
STEP 3
6
