INSTALLATION INSTRUCTIONS
1222 Instructions 3-9-15.doc
Page 3 of 5
Step 7:
Unplug (2) harness to the under side of
the top console.
Step 8:
Unplug connector to the power outlet
(inside the armrest).
Press in tab on top to release.
Step 9:
On the power harness included with the
Freedom Charge cut off the ringlet on the black
wire (ground).
Step 10:
Splice the wires using military splice or
soldering into the factory harness. (10a.) The red
wire connects to the grey/orange and the
black
wire connects to the black/purple wire. Wrap with
electrical tape or heat shrink. (10b)
10a
10b.
Step 11:
Remove rubber insert from inside
armrest and remove the (2) 10mm nuts from the
bottom studs.
Step 12:
Cut out provided template and mark
location for 1/2” hole.
