OPERATION
CAUTION: To avoid damage and voiding your warranty, place unit in its upright
position for a minimum of two hours before operating. DO NOT operate unit without
condensate water tank and air filter properly in place.
Cooling
This unit is intended to cool a 200-400 square foot area. The unit’s cooling capacity will
vary according to room temperature and humidity. Consult your Freecom dealer for spe-
cific application and suitability.
1.
Plug power cord into a standard household outlet. Use this
product only with the proper electrical voltage. See
“SPECIFICATIONS” on previous page.
WARNING: Do not plug this appliance into an outlet that is being used by other
appliances or electrical devices. When installing the electrical plug into the outlet,
never touch or bend the metal prongs and always push plug into outlet by using the
molded plug. Never use the electrical plug to start or stop the unit and avoid pulling,
folding, or stretching the electrical cord.
2.
Press “POWER ON/OFF” button on control panel. The unit will power up
and air will begin blowing from the front louvers.
NOTE: This unit is equipped with a special safety time delay feature.
The compressor (cooling mechanism) may be delayed for up to five
minutes. This safety feature prevents damage to the compressor.
The "COMP. ON" light will turn on while the compressor is running.
3.
Press “MODE” button on control panel to choose "FAN," "HI," "ME,"
or "LO." The FAN setting is for air circulation only and does not pro-
vide any cooling. To change from a cooling mode to fan mode,
press "POWER ON/OFF" button to turn unit off. Press "POWER
ON/OFF" button again and immediately press "MODE" button to
FAN setting.
4.
Press either "THERMO CONTROL" button to control a
colder or cooler setting. The default temperature is 75ÞF.
Press left button (COLD) to desired colder setting; right
button (COOL) to desired cooler setting. Each press of the
button will adjust the temperature approximately 3.5ÞF.
CAUTION: To avoid injury or damage and voiding the warranty,
DO NOT manually adjust the vertical louvers.
5.
Adjust horizontal louvers (up or down) as desired by moving the
louver handles up or down. The top louver handle controls the top
half of the horizontal louvers; the lower louver handle controls the
bottom half of the horizontal louvers. DO NOT adjust horizontal
louvers while vertical louvers are operating.
9
