24
2.9. Connecting communication cables
eProWallbox
is equipped with the following communication port:
1. 2x RS485
2. RFID
3. BLE
4. Wi-Fi
5. 4G/LTE
1.
Remove the protective cap from the right-hand box sheath (C) at the bottom of the
device, loosen it and insert the corrugated sheath Ø 25 mm.
2.
Insert the communication cable, pulling to a length that reaches the corresponding
communication port but leaving some slack.
Holes that are not used must be closed using the protective caps provided to ensure
the IP rating.
3.
Insert the desired connectors into the chosen communication ports.
4.
Repeat the procedure for every communication cable you wish to install.
For details on the available ports and connecting them, please refer to the “Port Description”
section.
The power supply of the device must remain switched off throughout this phase.
Failure to comply with these instructions can lead to serious damage to persons and
property, including death.
