Controls and Indicators
Front Panel
Top Panel
Side Panel
Press this switch to turn on/off the
effect. The LED on the right side of
the footswitch illuminates when ON.
ON/OFF footswitch
Press this switch to save the setting.
SAVE switch
Preset names and parameters of
each function are shown in this
display.
Display
Press this switch to change the
display. By holding down the switch
for about 2 seconds, the unit enters
Global Function Setup mode.
HOME switch
Adjusts the feedback amount of the
delay. When the Operation screen 2
or 3 is shown, the displayed
parameter can be adjusted by this
knob.
FEEDBACK knob/KNOB-C
Adjusts the tone of the delay sound.
When the Operation screen 2 or 3
is shown, the displayed parameter
can be adjusted by this knob.
TONE knob/KNOB-R
Power inlet for an AC-DC adapter. This unit can
be powered by an AC-DC adapter having
regulated 9-VDC output, center-minus polarity,
and min. 200 mA current. Use a standard 5.5 x
ø2.1 mm plug.
DC9V terminal
Input terminal to connect an instrument such
as a guitar/bass or an effect device. For a
monaural input, use a cable terminated with
mono phone plugs and for a stereo input,
with TRS phone plugs.
IN(TRS) terminal
Output terminal to connect an
amplifier or mixer, etc. If this unit is
set to be battery driven, inserting a
plug in this jack turns on the power.
OUT/L terminal
Output terminal to connect to an
amplifier or mixer, etc.
OUT/R terminal
Terminal to connect to an expression
pedal or external footswitch (momentary
type). CV (control voltage) is supported.
EXP/CV/FS terminal
Terminal to receive MIDI signal. The
optional CM-3510-TRS (MIDI cable)
is available for this purpose.
MIDI IN terminal
Used to adjust the parameter for
each function. On the HOME screen,
set the preset number to recall.
Turning this encoder when the
Operation screen 1 is shown adjusts
the delay time. When the Operation
screen 2 or 3 is shown, the
displayed parameter can be
adjusted by this encoder.
DELAY TIME (PARAM) encoder
These LEDs blink in BPM (tempo)
that has been set. When the preset
1 or 2 is recalled, the correspond-
ing LED illuminates.
PRESET/TEMPO LEDs
Used to page the Menu or Setup
screens. The left cursor
◀
key
operates as a page backward key
and the right cursor
▶
key as a
page forward key.
◀
/
▶
Cursor Key
Adjusts the mixing level of the
original and delay sounds. Turning
the knob clockwise increases the
delay sound level. When the
Operation screen 2 or 3 is shown,
the displayed parameter can be
adjusted by this knob.
MIX knob/KNOB-L
Used to input TAP tempo. Pressing
this footswitch for 0.5 seconds
recalls presets 1 and 2 alternately.
TAP footswitch
NOTE
In addition to an AC-DC adapter, this unit can be powered by a 9-volt Alkaline battery. Battery life for continuous use (depends on battery
type or usage condition): about 2 hours (Alkaline type. Note that a Manganese battery cannot be used due to its short life.)
The display shows “LOW BATTERY” when the battery voltage becomes low. Please exchange the battery or use with an AC-DC adapter.
To exchange the battery, remove the four screws on the bottom plate.
4
5
STEREO
MONO
When using monaural
input and stereo output,
remove the back cover
of the unit and change
the switch setting from
STEREO to MONO.