Remove all parts of the toilet seat except the seat itself
and the lid. This means removing the pad/feet on the
seat and lid and the hinges and fixings.
Then you should just have the bare lid and bare seat.
remove
Next, draw a line at the rear of the seat and lid and
cut the rear end off both. You only need to cut off
enough so that the two will have a flat back (as shown
right).
Now take two small hinges and screw lid to the seat
(see right).
Now screw, from the underside of the ply, the seat to
the seat plywood.
Cut a block to fit against the back of the toilet seat, in
between the two hinges, as shown right.
