6
7.2.1.
Speed control
•
rotary change - over switch : preset speeds selection (shown in FIG 3)
7.2.2.
"Run/stop"
•
change-over switch : function (refer to chapter 7
;
section 1.2.)
7.2.3.
Drive status indication
•
LED "FAILURE" (red) : internal or external trip
;
the drive is stopped (disconnected
from the load)
8. Reset of the drive after a trip signal
D
isconnect the drive from the supply for the short time and reconnect.
NOTE : restart of the drive ( "START" signal activation ) is recommended when the motor is stopped !
9. Options
9.1. FRECON TELECONTROL
- remote control unit
•
fault LED indication
•
run/stop : change-over switch
•
speed control : rotary change-over switch
•
dimensions : 110 x 80 x 55 mm (h x w x d)
•
mounting : externally anywhere convenient at a distance
permitted by a maximum cable length of 50 m from the
drive to the
TELECONTROL
9.2. EXTERNAL RFI FILTER
To conform to EMC standards, external RFI-filter is necessary to use.
RFI - filter is located in the separate cubicle with enclosure IP 44 or IP00 (on request) or IP20
Dimensions:
•
EMC emission according to EN 50 081-1,
Č
SN EN 55 011/B1:
FID-L18 ÷ 75
:
- enclosure IP00: 92 x
60 x 49 mm
FID-L18 ÷ 75
:
- enclosure IP44: 160 x
90 x 70 mm
FID-L110 ÷ 220
: - enclosure IP00: 92 x 60 x 56 mm
FID-L110 ÷ 220 : - enclosure IP44: 160 x 90 x 70 mm
FID-L250
: - enclosure IP20: 138 x 56 x 50 mm
•
EMC emission according to EN 50 081-2,
Č
SN EN 55 011/A1:
FID-L250
: - enclosure IP20: 138 x 56 x 50 mm
9.2.1.
Installation
To install the filter, follow the instructions in FIG 5
keep cables as
short as possible
2,5 mm
2
FIG.5
