Page | 7
① ②
The following must be ensured for the LCI Electronic Leveling System to work:
1.
the engine of the motorhome must be running,
2.
the parking brake must be engaged,
3.
the slide-out must be retracted,
4.
the RV must NOT be hooked up to external 110V power,
5.
the generator must NOT be running.
If all this is ensured, please follow these steps:
6.
Press the ON/OFF button
①
on the control panel. The system is now operational, and the buttons are
illuminated.
7.
Make sure that the LED next to ENGAGE PARK BRAKE is not flashing. If it is flashing, please set the parking
brake. The electronic leveling system is only operational if the parking brake is set.
8.
Press AUTO (automatic) button
②
to activate the automatic leveling function.
9.
Press the ON/OFF
①
button to turn off the system.
PLEASE DO NOT USE THE MANUAL OPTION
③
TO LEVEL THE RV BY USING THE SINGLE JACK BUTTONS
④
! IF
THE AUTOMATIC LEVELING DOESN’T WORK, PLEASE CALL OUR ONROAD SERVICE AT 1-866-535-6601!
CAUTION:
After you have started automatic leveling, it is very important that you no longer move around
in the motorhome until it is level and the green LCI logo in the centre of the control panel
illuminates. The leveling results may be affected if you move around in the motorhome while
leveling is in process.
Troubleshooting: Leveling Jacks
Problem
Cause/Solution
Leveling jacks cannot
be extended/retracted.
The breaker
②
right at the motor has been tripped due to
power overload. Check the leveling system's motor in the front
left area under the hood
①
. The small yellow switch is the
breaker of the motor. This breaker should be in a parallel
position to the motor. When the breaker is tripped, it is in a 45-
degree angle to the motor. If that is the case, press it back flat
against the motor, and check if the leveling jacks/automatic
step/rear view camera are/is now working.
④
⑤
③ ②
①
To retract the jacks please
1.
Start the engine
2.
Make sure that the parking brake is engaged
3.
Press the ON/OFF button
①
on the control panel.
4.
Press the RETRACT ALL JACKS button
⑤
.
5.
Press the ON/OFF
①
button when all jacks are retracted.