1
PAGE
VERSION:
200619
LICENSED FABRICATOR OF MAGNATRACK
CARE & MAINTENANCE and WARRANTY - MAGNATRACK SYSTEMS
CARE & MAINTENANCE and WARRANTY
MagnaTrack Systems
Fraser Shading Systems MagnaTrack Screen system is designed to protect and enhance your
outdoor dining area or living area, and create a usable space year‐round. The screen system can
be used for privacy, bug protection, solar, blowing winds (up to 120 KPH (75 MPH) in the full
deployed position), and to control the climate and wind flow.
OPERATION OF THE SCREENS
To LOWER the screen press the DOWN button on the remote and the screen will deploy to the
preset bottom limit:
*** Make sure no obstructions are under the screen during this process,
If the screen is lowered down on an object, stop the screen immediately
or the Obstacle detection feature in the motor will activate
and should raise back up to allow removal of object.
If the motor does not stop when object is under the screen during deployment, press the center
STOP button on the remote immediately and Remove object, then continue to lower the
screen:
‐ To raise the screen press the UP button on the remote and the screen will retract to the
preset limit.
‐ You can stop the screen at any position during the raising or lowering of the screen by
pressing the STOP button.
*** If the screen does not fully deploy to the floor, or the weight bar is hanging uneven
please leave the screen in that position and contact your authorized dealer ASAP.
***Raising the screen could cause additional damage.
RESETTING/ADJUSTING LIMITS ON SIMU/SOMFY MOTOR
(NOTED ON REMOTE)
‐ To adjust the limits, you must let the screen raise or lower
until the motor stops
! (even
if it is not to the desired position)
‐ When the screen is retracted or lowered to the Preset limit you wish to adjust PRESS
AND HOLD, BOTH THE UP AND DOWN AT THE SAME TIME (FOR 7 to 10 SECONDS) UNTIL
THE MOTOR/WEIGHT BAR JOGS UP/DOWN.
‐ After the motor jogs you can raise or lower to the desired position.
‐ THEN, PRESS AND HOLD THE STOP BUTTON UNTILL THE MOTOR JOGS to encode the
new limit setting.
This will complete the programming process and change the limits.
