3
OVERLOAD RELEASE.
The overload release near the three-point lift is a safety guard
which allow the cutter bar swing backward if it hit's into the
ground,
when it happens then stop the PTO. and drive backward and
the overload release are going to lock again.
TRANSPORT POSITION
Change-over from working position to transport position is as
follows:
Lift the machine from the ground. Tilt the front swath guard
backwards and drag the canvas free of the brackets, so it not
is getting damaged.
Drag the cutter bar up into vertical position by means of the
hydraulic cylinder and lock it by means of the safety chain.
Turn the transport lock (A) on, in the left side.
ORDERING SPARE PARTS
The spare part order must contain the following information:
1. Machine type.
2. Spare part number and description-possibly dimensions and number of parts.
LUBRICATION AND MAINTENANCE
Lubricate PTO shaft after every 10 hours of operation, and lubricate the indicated lubrication points
as and when
required.
Retighten bolts.
Correct tighten of knife bolt - 10 kpm.
Correct tighten of disc bolt - 17 kpm.
Check the V-belts before every start, when the V-belts is proper tightened it can be pushed approx. 20mm. in the
middle between the pulleys.
The V-belts conditions have to be checked by dismount the cover.
Is a V-belt defect, exchange the whole set.
Is the machine put away for the winter, the V-belts has to be released.
At regular intervals, and at least twice a week, check the cutter bar for dirt and clean if required.
An unbalance will reduce the life of the bar.
Check the oil level in the gearbox, by means of the level indicator under the plug on top of gearbox the cutter bar
must be horizontal.
The gearbox is filled with 0,7 litres of SAE 80/90 W gear oil. It should be checked daily and topped up if necessary.
Check oil level on the cutter bar when it is in vertical position, on the disc side there is one plug, for controlling oil
level and filling oil into the bar.
Under the cutter bar in the bottom is one plug (A) for taking oil of the bar.
The cutter bar is filled with 3,2 litres of SAE 80/90 W gear oil. It should be checked daily and topped up if necessary.
Change oil after approx... 10 hours of use, and then every 100 hours at least once a year.
Summary of Contents for DM-2850
Page 1: ...Fransg rd Manual GB Disc mower DM 2850 From serial number 57450001...
Page 7: ......
Page 8: ......
