Franklin Electric inline 1100/cp, Install Manual

Page: 3 / 8

Tools and Hardware Required
Phillips head screwdriver and adjustable wrench.
s
ATTENTION !
This equipment is intended for installation only by technically qualified personnel.
Failure to install it in compliance with national and local electrical codes and
within Franklin Electric’s recommendations may result in electrical shock or fire
hazard, unsatisfactory performance, and equipment failure.
s
WARNING !
Serious or fatal electric shock may result from failure to connect the Inline System
to the service entrance ground. Also ground metal plumbing and all other metal
near the Inline System. When grounding these components, use a wire no smaller
than the power supply wires from the circuit breaker to the Inline System. To
reduce the risk of electric shock, disconnect power before working on or around
the water system.
CAPACITORS INSIDE THE INLINE SYSTEM CONTROLLER CAN STILL HOLD
LETHAL VOLTAGE EVEN AFTER POWER HAS BEEN DISCONNECTED.
ALLOW 5 MINUTES FOR DANGEROUS INTERNAL VOLTAGE TO DISCHARGE
BEFORE REMOVING ACCESS PANEL.
This pump has not been investigated for use in swimming pools or marine areas.
Purpose
Thermostat kit is used to replace the external thermostat on the Inline 1100/CP.
The kit contains all of the parts and components necessary to completely replace the
existing external thermostat.