FRANKIA OPERATING MANUAL
62
FRANKIA OPERATING MANUAL
63
Clock displays:
The measurement and display values of the clock and thermometer functions are scrolled through with Button 2 (middle).
•
Time:
The current time is displayed. The colon between hours and minutes flashes every second.
•
Date:
The display of the date can be recognised by the separating point between day and month.
Battery computer displays:
•
The measurement and display values of the battery computer functions are scrolled through
with Button 1 (left).
•
Voltage:
The voltage of the on-board batteries (B1) and the starter battery can be displayed. The
marking triangles at the bottom of the display point to the displayed battery.
•
Current:
The current display provides information about the load or charge of the battery at
that time. The display shows the measured current, which flows in or out of the battery at
that time. If the current flows into the battery, the display shows a positive current as well as
the charging symbol “CHARGE”. If the current flows from the battery, it is negative and is shown
with a minus sign.
•
Capacity display:
The capacity of the on-board battery is displayed in ampere hours (Ah) and
in percent (%) of the nominal capacity. The bar graph on the left of the display also shows the
capacity in 10% steps.
•
Remaining time display:
The remaining runtime is calculated from the remaining capacity
(up to the set switch-off threshold) and the current at that time. Of course, if no current flows
from the battery, no remaining period can be calculated. A -.- is then displayed.
Please note the battery capacity indicator on your battery computer. If the usable capacity falls below 30%, a flashing
display should indicate that less than 30% of the battery capacity can still be used and should be recharged if neces-
sary. (see chapter 4.8. - On-board batteries)
Operation:
Button 1: Switching the battery computer displays
Button 2: Switching the clock and thermometer displays, programming the
Home
screen
(3s)
Button 3: Switching the display on/off, menu (3 s) Menu (3s)
Switch on, switch off:
Standby:
In standby mode, the display has no content. “ON” only appears when the switching output is switched on and the arrow
above the word “Hybrid” if the EFOY is to run in hybrid mode.
Display with and without lighting:
When the MT 5000H is operated, the display lighting is switched on and remains activated for 3 minutes. If no further
operation takes place within this time, the lighting switches off automatically. The display continues to show the same
content, as with the lighting Pressing any button again activates the display lighting again. Only the second press on a
button performs the actual function of the button.
Switch on from standby:
From standby, the device can either be switched on completely or only the clock function. If Button 2 (middle) is pressed
to switch on, switching can only be done between the clock and thermometer displays. The MT 5000H will in any case
automatically return to standby mode after 30 seconds. If all functions of the MT 5000H are to be displayed, the device
must be switched on with Button 3 (right). Now it remains switched on until you press Button 3 (right) again to put the
device back into standby mode.
voltage on-
board battery
current on-
board battery
remaining
capacity on-
board battery
remaining
capacity on-
board battery
remaining
capacity on-
board battery
voltage on-
board battery