1. Once you have unpacked your ARU-480, remove the lid, locate and retrieve your mounting hardware, wheels (hardware) and
adjustable feet. Choose which you would like to use and install before weighing down with pavers and/or weights.
2. After you have installed the wheels or feet, pavers should be placed in the base corner towards the center first (
FIGURE 1
), under the
mounting plate. Repeat in each quadrant until the base is full with Twelve (12) appropriately weighted pavers.
3. After your base is sufficiently weighed down, place the lid back onto the base (
FIGURE 2
), lock your wheels if installed, and retrieve
your Spigot (
35
) from the mast of the Aurora
4. Mount your Spigot (
35
) to the ECU-480 with the included mounting hardware on the outer threaded pattern (
FIGURE 3A
).
5. With your Spigot in place and on 480 Mounting Plate, use the supplied hardware that is packed with your umbrella and bolt the Spigot
onto the plate threading down to only the plate
FIGURE 3
). Once your Spigot is threaded down, begin to lift the Aurora onto the Spigot
until you hear an audible “click” indicating your umbrella is secure.
IMPORTANT: Your umbrella mounting hardware, wheels (hardware) and adjustable feet are packed within the base. Remove the lid to
locate and retrieve your hardware and accessories. Proceed to remove the grub-screws from the mounting plate on the ARU-480.
TOOLS & MATERIALS NEEDED
•
A trusted level (if adjustable feet are chosen)
•
Twelve (12) Concrete Pavers (recommended weight 35 lbs. +) 2” x 16” - Most pavers have a tolerance and may be
smaller. The weight is most important. Minimum weight per quadrant 100-110lbs.
•
1/2” Crescent or box wrench
16” x 16” x 2”
FIGURE 1
16” x 16” x 2”
3 Pavers
3 Pavers
FIGURE 2
FIGURE 3A
AURORA MOUNTING
Your Aurora comes with the Spigot (
35
) already inserted in the mast of your umbrella. Once you have properly leveled your base (If
adjustable feet used) or have installed the caster wheels and have them in the locked position, you can begin to mount your Spigot (
35
)
and then umbrella. (see
FIGURE 1
).
FIGURE 3
.7
5
” X .
5
” (
8
M
M A
LL
E
N K
E
Y
)
ARU-480 ROLLING BASE
GRUB-SCREWS ARE IN PLACE TO PROTECT THE THREADED HOLES ON BASES
DURING SHIPPING AND STORAGE. THEY MUST BE REMOVED AND DISCARDED
BEFORE THE INSTALLATION OF ANY UMBRELLA.
AURORA
8
M
M
A
LLE
N
W
R
E
N
C
H
(MO
UN
TIN
G
H
A
R
D
W
A
R
E
)
6
M
M
A
LLE
N
W
R
E
N
C
H
(R
E
MO
V
E
G
R
UB
-S
CR
E
W
S
)
X16
X16
X16
X1
: 6MM ALLEN WRENCH
(ADJUSTABLE FEET SPECIFIC)
A
D
J
U
S
TA
B
LE
F
EE
T
X4
27
28
INCLUDED ARU-480 SPECIFIC MOUNTING HARDWARE
