54
5.3 Replacing of the illuminant
1.
WARNING! The LED-illuminant must be replaced by a competent person only. If the
LED-illuminant is damaged, please contact a qualified professional.
6. Trouble shooting
MALFUNCTION
POSSIBLE CAUSE
MEASURE
The appliance does not work at all.
The plug of the appliance is not
connected to the socket.
The plug has become loose.
The socket is not supplied with energy.
The fuse is switched off.
The voltage is too low.
Check the corresponding socket by
connecting it with another appliance.
Check the fuse box.
Compare the data on the model plate
with the data of your energy supplier.
The compressor does not work at all.
Incorrect energy supply.
Check the energy supply.
The compressor operates for too long.
The appliance has been switched off for
a while.
Too much or too hot food in the
appliance.
Doors opened too often or too long.
The appliance needs some time to
reach the preset temperature.
Remove any hot food.
Do not open the door too often/too
long.
Formation of encrusted ice.
The air outlets may be blocked by food.
The door is not properly closed.
The door seal is damaged or soiled.
Store the food in another place.
Close the door.
Clean/replace the door seal.
The door makes a strange sound when opened.
The door seals are soiled.
Clean the seals.
Uncommon noise.
The appliance is not installed on a flat
and level ground. The appliance
touches a wall or other object
Frozen food is stored improperly.
Items have dropped behind the
appliance.
Install properly.
Store food properly.
Remove the items.
Water drips on the floor.
The water pan (located at the rear
bottom of the cabinet) may not be
properly levelled, or the draining spout
(located underneath the top of the
compressor depot) may not be properly
positioned to direct water into this pan,
or the water spout is blocked.
You may need to pull the refrigerator
away from the wall to check the pan and
spout.
