– 8 –
TE-45
/ TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF
EN
X
X
Attach disposer onto the upper mounting ring
by aligning the three mounting tabs on the
lower mounting ring with the slide-up ramps on
the upper mounting ring and rotating counter
clockwise.
A
C
B
X
X
The lower mounting ring (which is part of the
disposer) has 3 tabs that grab the mounting ring
ramp.
(
A
) points to the upper mounting ring.
(
B
) is the tab that slides up onto the “Ramp”.
(
C
) is the „Ear“ that is used to help rotate the lower
mounting ring.
X
X
Use a screwdriver for leverage if needed.
D
X
X
Lift and turn the lower mounting ring counter
clockwise until all three mounting tabs lock over
the ridges (
F
) on the slide-up ramps (
D
) of the
upper mounting ring.
F
E
X
X
As the lower mounting ring is turned counter
clockwise each tab slides up onto the upper
mounting ring ramp (
E
) and locks in position over
the ridges (
F
).
X
X
Use a screwdriver or hammer for leverage if
needed.
X
X
If a disposer needs to be removed, tapping on the
Ear clockwise with a hammer will easily loosen
the lower mounting ring.
Electrical connection
X
Z
Connect disposer to appropriate
household current only.
The receptacle to which this appliance is connected
must be controlled by a switch.
WARNING:
Improper connection of the
equipment-earthing conductor can result in a
risk of
electric shock
. Check with a qualified
electrician or serviceman if you are in doubt as to
whether the appliance is
properly earthed
. Do not
modify the plug provided with the appliance if it will
not fit the outlet. Have a
proper outlet installed
by
a qualified electrician.
Earthing instructions
FOR WASTE DISPOSERS EQUIPPED WITH AN
EARTHED PLUG-IN POWER CORD
X
Z
This appliance must be earthed. In the event of
a malfunction or breakdown, earthing provides
a path of least resistance for electric current to
reduce the risk of electric shock. This appliance
is equipped with a cord having an equipment-
grounding conductor and a grounding plug.
X
Z
The plug must be plugged into an appropriate
outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
X
Z
If the supply cord is damaged it must be replaced
by the manufacturer, its service agent or similarly
qualified person in order to avoid a hazard.
Removing an attached power cord or plug voids
the warranty.
The following UK Electrical Section is for United
Kingdom only - skip if not applicable
.
WHEN USING THE ATTACHED PRE-WIRED MOULDED
PLUG AND LEAD (fig.
3A
)
9
These disposers are engineered to be connected
to a 220/240 V~-50/60 Hz electrical supply
through the attached three-pin plug and into a
wired socket.
9
The disposer must be protected by a BS 1363 13
Amp fuse. The fuse is included within the molded
plug and lead, attached to the disposer.
9
The 13 Amp double pole switched spur switch
should be positioned higher than the sink
