
•
Selected drying time
After selecting a drying programme, the
drying time is displayed in minutes or in
hours and minutes (e.g. 130 mins =
2.10
).
After the programme has started the time
remaining is updated every minute.
•
Delayed start
The Selected delay set by pressing the rel-
evant button appears on the display for
few seconds, then the duration of the se-
lected programme is displayed again.
•
Alarm codes
In the event of operating problems, some
alarm codes can be displayed, for example
E20
(see paragraph «What to do if...»).
•
Incorrect option selection
If an option which is not compatible with
the set wash programme is selected, the
message
Err
is displayed at the bottom of
the display for a few seconds and the in-
tegrated red light of button
8
start flashing.
•
End of programme
When the programme has finished three
flashing zeros are displayed, the pilot light
9
and the pilot light of button
8
go out and
the door can be opened.
First use
• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
• Remove the polystyrene block and
any material from the drum.
• Before the first wash, run a cotton cy-
cle at the highest temperature without
any laundry in the machine, to remove
any manufacturing residue from the
drum and tub. Pour 1/2 a measure of
detergent into the main wash com-
partment and start the machine.
Personalisation
Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the
4
and
5
buttons simultane-
ously for about
6 seconds
, the acoustic
signal is deactivated (except if there is a fault).
By pressing these 2 buttons again, the
acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appli-
ance unattended and not to worry that chil-
dren might be injured by or cause damage to
the appliance. This function remains enabled
also when the washing machine is not work-
ing.
There are two different ways to set this op-
tion:
1. Before pressing button
8
: it will be im-
possible to start the machine.
2. After pressing button
8
: it will be impos-
sible to change any other programme or
option.
To enable or disable this option press simul-
taneously for about 6 seconds buttons
2
and
3
until on the display, the icon
appears or
disappears.
Daily use
Washing only
Load the laundry
Open the door by carefully pulling the door
handle outwards. Place the laundry in the
drum, one item at a time, shaking them out
as much as possible. Close the door.
8