EN
8
8
USE
A
B
C
D
E
F
G
H
Control panel
Button
Function
Display
A
Turns the suction motor on and off at speed one.
Displays the set speed
B
Decreases the working speed.
Displays the set speed
C
Increases the working speed.
Displays the set speed
D
Activate
intensive
speed from any other speed,
including motor off. This speed is set to operate
for 10 minutes, after which the system returns to
the speed that was set before. Suitable to deal with
maximum levels of cooking fumes.
Displays
HI
and the time remaining once very second.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter
alarm On and Off.
FC
+
Punto
(2 flashes)–Alarm On.
FC
+
Punto
(1 flash)–Alarm Off.
E
24H function
Turns the suction motor on at speed one and
effects one 10 minute extraction every hour.
Displays
24
and the spot at the bottom right flashes once
every second, while the motor is running.
It is disabled by pressing the button.
When the filters alarm is triggered, the alarm can
be reset by pressing and holding this button for
approximately 3 seconds.
These indications are only visible when the motor
is turned off.
FF
flashes three times.
When the procedure terminates, the indication shown
previously turns off:
FG
indicates the need to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 100 working hours.
FC
indicates the need to change the activated charcoal
filters, and also to wash the metal grease filters. The alarm
is triggered after the Hood has been in operation for 200
working hours.
F
Delay function
Activate automatic switch-off with a 30’ delay.
Suitable to complete elimination of residual
odours. Can be activated from any position, and is
disabled by pressing the button or turning the
motor off.
Displays the operating speed and the spot at the bottom
right flashes once a second.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Remote Control On and Off.
IR
+
Punto
(2 flashes)–Alarm On.
IR
+
Punto
(1 flash)–Alarm Off.
G
Turns the lighting system on and off at maximum
intensity.
H
Turns the Courtesy Lighting on and off.
