EN
7
7
Fitting the hood body
• Adjust the two screws
Vr
, in the brackets
11a,
so that
they are at the start of their travel (
B
).
• Hook the hood body to the two brackets
11a
.
• Remove the Grid by pulling it, paying attention to the
electrical connections for the Spotlights. (see
paragraph on Maintenance).
• From the inside of the hood body, turn screws
Vr
to
level the hood body itself.
• Fasten the safety screw
11
.
• Replace the Grid.
( B )
11
Vr
11a
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to
the chimney using either a flexible or rigid pipe ø 150
or 120 mm, the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection, insert
the reducer flange 9 on the hood body outlet.
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
• Remove any activated charcoal filters.
ø 150
9
ø 120
