TECHNICAL DATA
NOTE:
CONTENTS IN BOX
INSTALLATION INSTRUCTIONS
Contact us immediatly if you see inconsistencies.
Phone: (1- 800-626-5771)
website: www.franke.us/ks
email: [email protected]
Flow Rate
Recommended Water Pressure
Max. Water Pressure
Recommended Hot Water Temp.
Hole Size For Faucet
Certifies this faucet complies with ASME A112.18.1 / CSA B125.1
& NSF 61, NSF 372 and AB1953
1.75 GPM at 60 PSI
30-75 PSI
145 PSI
120°-140° F
1 3/8”
1
Faucet assembly
2 Rubber washer
3
Rubber washer
4
Plastic flange
5 Fixing plate
6
Fixing nut
1
5
6
2
4
3
8
10
7
11
12
9
12 Key for aerator
7 Pull out Supply hose
8
Spray hose
9
Weights
Screws
Supply hoses
10
11
1. Remove all contents from the package and check for completeness.
2. Turn off water supply.
3. Cut a mounting hole 1 3/8 diameter (35mm) in the desired position in
counter top or sink (if one isn’t available).
4. Place the rubber washer (2) over the mounting shank.
ATTENTION: The washer should be sitting between the countertop and
faucet base.
DO NOT use putty or other sealant at this location.
NOTES:
Solid surface installation: The countertop mounting surface needs to
be flat and free of debris otherwise the faucet may not sit properly.
For tile installations, avoid installing faucet near or on top of grout lines.
This may cause a weak joint between the faucet and the counter and
could cause leaks.
5. Install the mounting hardware to the base of the faucet body in
the following order - rubber washer (3) plastic flange (4) and fixing
plate (5) as ilustrated
6. Secure the faucet by tightening the Fixing Nut (6) onto the
mounting shank of the faucet the body (1).
2
5
1
4
3
6
2” (50 mm)
9. Connect the flexible supply hoses (11) to the water supply in the
house.
7. Connect the pull out hose (8) to the pull out supply hose (7) using the
quick connect fitting. Slide the quick connect fitting sleeve to the
"open" position, insert the hose fitting into the connector. You should
hear a "click". Slide the sleeve to the "lock" position, you should hear
another "click". This will ensure the fitting is sealed and locked.
8. Place the weights (9) on the spray hose (8) with the screws (10).
Approximately 2” (50mm) above the bend in the bottom of the spray
hose.
7
11
8
10
10
9
9
10. Remove the aerator using the aerator key, turn on water, flush the
faucet for any debris and check for leaks.
Reinstall the aerator and ensure everything is functioning properly.
