EN
6
6
WARNINGS - COMPONENTS
WARNINGS
This appliance has been designed for use as either an
EXTRACTION
(ducting to the outside) or
RE-
CIRCULATION
(filtering) hood. The measurements contained on the drawings in this booklet refer to
two models of cooker hood. Therefore, it is essential that you refer to the correct drawing when taking
measurements for installation.
- The minimum distance between the cooking surface and the metal grease filters on the underside
of the hood must be 650mm.
- This cooker hood must be installed in accordance with the installation instructions and all re-
quirements must be adhered to.
- If the room where the cooker hood is to be used contains a fuel burning appliance such as a cen-
tral heating boiler then its flue must be of the room sealed or balance flue type.
- If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the
room.
- When the range hood and appliance supplied with energy other than electricity are simultane-
ously in operation, the negative pressure in the room must not exceed 4 Pa (4x10
-5
bar).
- The ducting system for this appliance must not be connected to any ventilation system which is
being used for any other purpose.
- The ducting system for this appliance must not be connected to any existing ventilation system
which is being used for any other purpose.
- Do not leave naked flames or carry out flambè cooking under this cooker hood.
- This appliance is not intended for use by persons (including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience and knowledge, unless they have been given su-
pervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
CONNECTING THE POWER CABLE TO THE MAINS POWER SUPPLY
Before installation, check that the mains voltage indicated on the rating plate inside the appliance corre-
sponds to the voltage available in your home. If the Hood is not fitted with a plug, fit the power cable with
a plug of a type approved for the load indicated on the rating plate; when connecting directly to the mains,
insert an omnipolar circuit breaker with a minimum contact aperture of 3mm and a size suitable for the
load in question between the appliance and the mains supply, making sure it is of a type that complies with
current regulations.
COMPONENTS
- 2 No Wall Brackets
C
- 1 No 150-120mm Ducting Spigot
G
- 1 No Air Outlet Connection
H
- 2 No Charcoal Filters
L
(Optional)
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall
be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could oth-
erwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please
contact your local city office, your household waste disposal service or the shop where you purchased the product.
