Preparation
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grouped for free-standing or wall-hanging use. Check the parts list to make
sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included):
Phillips screwdriver; stud finder; level; tape
measure; electric drill; 1/4” wood drill bit, hammer.
Parts and Hardware
This product includes a
GLASS panel!
Always use
extreme caution
when handling
glass.
Failure to do so could result in
personal injury
or
property damage
.
ALWAYS
check your fireplace cord and plug connections with
each use
!
i)
MAKE SURE
the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs
can
cause the outlet to overheat.
ii)
fireplaces draw more current
than small appliances.
Overheating
may occur even if it
has
not occurred with the use of other appliances.
iii)
During use
check frequently
to see if the
plug outlet or faceplate
is
HOT
!
iv)
If the outlet or face plate is
HOT
,
discontinue use immediately
and have a qualified
electrician inspect and/or replace the faulty outlets.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their
safety. Children should be supervised to ensure that they do not play with the appliance.
