Adjusting the 45° Angle
Set the guide on either side and place the 45°
triangle so it is completely touching the guide. If
there is no gap along the disk surface or along the
fence, the angle is exactly 45°.
If there is a gap or movement, then you will
need to correct the angle. You will do this by
using a 4mm allen wrench in the adjustment
screw located in the center of the adjusting
bracket. Turn the adjustment screw so the
triangle is completely touching the guide and
the disk. Your sander is now adjusted to a 45°
angle.
6
© 2017 framingsupplies.com
All Rights Reserved
Adjust Here
