![background image](http://html1.mh-extra.com/html/fram/fwm-v814t2d/fwm-v814t2d_instruction-manual_2326404036.webp)
35
ELECTRICAL CONNECTION
•
Your washing machine is set to 220-240V and 50Hz.
•
The mains cord of your washing machine is equipped with a specific earthed plug. This plug should
always be inserted to a earthed socket of 10 amps.
•
The current value of the fuse should be 10 amps. Fuse current value of the power line connected to
this plug should also be 10 amperes.
•
If you do not have such a receptacle and fuse confirming with this, please have it done by a qualified
electrician.
•
We do not take the responsibility of the damages that occur due to ungrounded usage.
NOTE: Operating your machine under low voltage will cause the life cycle of your machine to be reduced
and its performance to be restricted.
WATER INLET HOSE CONNECTION
•
Your machine may have either a single inlet (cold) or double water inlets (cold/hot) based on its
specifications. White-capped hose should be connected to cold water inlet and red-capped hose to hot
water inlet (applicable for machines with double water inlets).
•
To eliminate water leakages in points of contact, 1 or 2 nuts are provided in the hose package (applicable
for machines with double water inlets). Fit these nuts to the ends of new water inlet hoses on the side of
faucet.
•
Mount new water inlet hoses to a ¾ ˝, threaded faucet.
•
Connect the white-elbow end of the water inlet hoses to the white-filtered water inlet valve on the rear
side of the machine and the red-elbow end to red-filtered one (applicable for machines with double
water inlets). Tighten plastic parts of the junctions using your hand. In uncertain conditions, have the
connection works be done by a qualified plumber.
•
Flow of water with pressure of 0,1-1 Mpa will allow your machine to operate more efficiently.) (0,1 Mpa
pressure means that more than 8 liters of water will flow through a fully-tapped faucet per one minute.)
•
Ensure that points of contact do not leak by tapping the faucet completely after carrying making the
connections.
•
Ensure that the new water inlet hoses are not bent, broken, crushed and resized.
•
If your machine has double hot water inlets, the temperature of hot water inlet should be maximum
70°C.