Block diagram
Quick Settings Guide
Preliminary indication
IMPORTANT: Before starting the configuration, it is advised to set the AREA or COUNTRY in order to select
the correct VHF-UHF frequency plan.
•
Power off the device,
•
Push the “confirm button” and keep it pushing while you turn-on the FRPRO EVO HD.
•
Release the button when “RESET FINISHED” message is shown on display.
•
To activate the correct frequency plan select the COUNTRY where the FRPRO EVO HD is situated and
save with the “confirm button”. Europe is the default setting.
For detailed instruction, please download the full user’s manual from the relative product’s page on
www.fracarro.com
.
•
Power up the FRPRO EVO HD by using the 220V power cord included in the package. The FRPRO
EVO HD will need approximately 5 secs to initialize itself. The FRPRO EVO HD configuration can be
performed by using the three settings buttons and the display available on the top front (see block diagram
above).
•
Press the “confirm” button for two seconds to access the different menù or for confirm the selection. Scroll
all the menu by using left-down or right-up arrows for move through the different menù.
Input settings
•
Select “
INPUT FM
” to setup the desired FM input signal gain.
•
Select “
INPUT 1…4
” to enter the VHF/UHF input settings (NOTE: the first TV channel selected determine
if the INPUT becames a VHF or UHF input only).
•
Turn ON the “
PRE-AMPLI
” section in order to enable the pre-amplifier stage if the RF input level are very
critical.
•
Turn ON the “
DC
” if is necessary to insert the power supply to the external must amplifiers (max 100mA
for the 4 VHF/UHF inputs)
•
Select “
ADD CHANNEL
” to add the RF channel on the list of the filetered/converted channels managed
from the relative input (NOTE: to delete the unwanted RF channel, move on the position of the channel by
using left/down ot right/up arrows buttons and press the “confirm” button for 3 seconds until “Channel
Deleted” message is shown on display).
Output settings
Grounding Clamp
RF Test (-30dB)
SD Card slot
Mains Power supply socket
TV inputs: FM + 4x VHF/UHF
Setting’s buttons
(left/down, confirm, right/up)
RF Output
Led Status
Display
