Page | 18
Read carefully all warnings on the packages of greases and lubricants. After the work on greasing, the
operator - servicer must thoroughly clean parts of the body of the grease and lubricants.
The grease/lubricant that was used must be disposed in the prescribed manner, in compliance with the Law
on Environmental Protection.
REPLACEMENT OF V-BELT
V-belts are properly tightened if the deflection is max. 10 mm to prevent excessive slipping.
Inadequately tightened belts are the cause of poor performance of the mulcher and early damage and tear of
belts.
When replacing belts, or check their tightness, do the following:
Unscrew the nuts and remove the protective coating of the V-belts
Loosen the screw that holds the housing of the drive sheave
Tighten the adjustment screw to the extent necessary to provide the necessary tension of the belts
Tighten control nut of the adjustment screw
Tighten all screws that hold the housing of the drive sheave
Put the protective layer back to its place.
All parts of the transmission from reductor to the drive sheave must be in line when tightening of belts.
Loosen
the screws on the reductor board, lift or lower the reductor, so that the transmission shaft is parallel to the top
plate of the tool, then tighten the screws.
Make sure whether the sheaves are in the same line when tightening or changing the belts. To check, use a metal
ruler that must be placed on both sheaves’ area.
The edge of the
ruler must adhere to all four points.
WARNING:
IT IS NECESSARY AND IMPORTANT TO CHECK THE BELT TIGHTNESS AND TO
TIGHTEN THEM PROPERLY.
IT IS VERY IMPORTANT TO DO THAT AFTER 0.5
HOURS OF USAGE OF THE TOOL. WHEN REPLACING THE WORN BELTS,
REPLACE THE SET OF BELTS, REGARDLESS OF THE STATE OF ONE BELT
COMPARED TO THE OTHER.
LUBRICATION
It is very important to properly lubricate any tool, both the transmission and all parts that slide one inside the
other, in order to meet the strict requirements for working in the most difficult conditions, which is of vital
importance for the long life and functionality of the tools.
Therefore, lubrication must be performed regularly - at certain time intervals.
The time interval for the lubrication
provided in this Manual relates to the tool that is used in normal conditions.
If the tool works in hard working conditions, then lubrication must be performed at shorter intervals
.
Summary of Contents for 618 192
