15
FPI U31-2 Gas Fireplace Insert
BAY FRONT
INSTALLATION
1)
Place the bay door onto the 2 pins on the
top of the unit.
2)
Install bottom louver by sliding the two
bracket clips into the brackets located
underneath the bay door and secure with
2 screws into the bracket on the bottom of
the Bay Front as per diagram above.
3)
Slide the valve extension knobs onto the
valve knobs. match the correct ext. knob
with the valve knob.
BAY LOUVERS
1)
Install top louver by sliding the two bracket
clips into the brackets located on top of the
bay door. See below. The fi tted louver leaves
a small gap between faceplate bottom and
louver top.
INSTALLATION
FLUSH LOUVERS
3) Place the bottom of the fl ush glass behind
the bottom glass trim.
4) Secure the glass with the two glass clips at
the top corners of the glass. Secure glass
clips with the screws provided. Do not over
tighten as this could break the glass.
5) Slide in the top glass trim under the spring
clips.
2)
Position 2 magnets on the back of each trim
piece close to the ends. Place the top and
bottom trim pieces on the bay front.
3)
Install top and bottom louvers.
Note: The top and bottom trim pieces are
different, check diagrams above and
below.
DOUBLE DOOR
SCREEN
1) Pull
out
the
top louver
and the top
glass trim.
2) Loosen the
screws so
the glass
c l i p s c a n
be turned
aside and
t h e f l u s h
g l a s s r e -
moved.
1)
The Top Louver is held in place by friction
fi t, if the Louver needs to be adjusted; bend
the bracket out as shown in the diagram.
2)
Install the Spring Hinges on the left and right
side of the bottom of the Firebox using 2
screws per hinge.
Bottom Louver
Hinge
Location
3)
Place the Bottom Louver near the hinge. Flip
hinge over the Bottom Louver and secure
using 3 screws.
