Page 4 FPI FireWizard
TM
Remote Control Manual - IPI
Matching Remote Handset and Control Box ID Code
The Remote Control Handset has a set of unique ID codes that is pre-programmed into its
memory. This set of ID codes helps to differentiate one Remote Control Handset from
another so that only the control box with a matching ID code will respond to the
appropriate Remote Control Handset.
To ensure the remote control is matched to the receiver correctly, please follow the steps
below:
1.
Install the 2 x AAA alkaline batteries into the Remote Control.
2.
Unplug and re-plug the power cord. The power cord is located on the left hand side of
the appliance and will be plugged into the receptacle.
3.
Press and hold the PROG and FAN buttons simultaneously for up to 20 seconds.
During this time, the remote will display LC while it is transmitting codes to the
receiver.
4.
Once it is successfully transmitted, wait for 20 seconds and press the ON/OFF button
on the remote control once and the burners will come on.
If is does not work the first time, repeat steps 2 and 3.
5.
The remote control is now programmed to the receiver and the appliance can now be
operated with it.
The control box will only learn the Remote ID codes during the first 30 seconds after
power is applied and will ignore this special command from the Remote after the first 30
seconds.
NOTE:
This must only be performed by a qualified installer.
