FP FPi2000, Operator'S Manual, Page: 19 / 26

19
ENGLIS
H
Code position and free area
The code must be printed minimally 15 mm
(0.59 inch) away from top and 30 mm (1,18
inch) from the bottom of the sheet. Default the
first mark from the top is set to 100 mm (3.9
inch). From the left hand and right hand side 7
mm (0.28 inch) must be kept clear. The code
must appear in the same location, and have a
consistent number of marks on every page.
Length
Above the first mark and below the last mark a
space of 8,5 mm (0.33 inch) must be kept
without printing. This means that the minimum
code area consists of 6 lines, 2 lines to print the
(basic) and 4 lines free space. Line distance
may be 2,54 mm (0.1 inch) to 6,35 mm (0.4
inch).
Code width, character space and pitch
The minimum width of the code area is 7
character spaces. From left to right: first 2
characters space unprinted (5 mm; 0.20 inch),
then the track mark (3 characters or 6,3 mm; 0.4
inch) and finally 2 character spaces unprinted.
Pitch 10 or 12 is accepted. The track mark can
be printed by using the “underline” sign (__),
which must have a thickness of at least 0,2 mm.
Parity mark
By adding a parity mark the reading code can be
checked. When the OMR-2 code is used the
sum of the marks has to be even.
Safety mark
The safety mark is used as an extra security.
With skewed paper the reading head can miss
part of the reading code. In these situations the
safety mark is not read, and the system will give
an error. The safety mark also indicates the end
of the reading code. This mark always has to be
printed on the document if it has been activated.
Criteria:
• the marks chosen are always used in the
above sequence,
• if a function is suppressed the following
function will move upwards one line,
• the chosen code is used on all material which
will be processed by the Optical Mark
Reading,
• the length of the code with it's mark definition
is a service setting.
7. FAULT FINDING
7.1 General
In the system the following error types are
possible:
• paperflow errors,
• reading errors (when the system is equipped
with Optical Mark Reading),
• technical errors.
If an error occurs the display shows a screen
with an error description and a suggested
solution.
When a paperflow error occurs the following
functions are available:
• show more information,
• reset the error after solving the problem (the
error screen will disappear).
The black arrow or a black feeder indicates
where the problem occurs.
When a reading or double feed control error
occurs, the document stops in the collator area.
The operator must remove the document(s) from
the collator area and must complete the set
manually!
When there is a technical problem the display
shows a message. The error cannot be solved
by operating personnel and assistance of the
service support is needed.
First write down the error code, then switch the
inserter off and on again, to verify system operation.
When the error still occurs contact your service
organization.